180 bag single machine dust collector

Precautions when using a 180 bag standalone dust collector:

1. The trapezoidal hole of the flower board should be perpendicular to the corresponding positioning ring on the lower bracket to prevent air leakage when the dust filter bag is placed in the frame and tilted upwards.

2. Place the filter bag outside the rack of the dust removal filter bag, press the bag mouth and guide with a pressure strip to prevent leakage, and then carefully insert it into the flower board (be careful not to scratch or scratch the filter bag). Insert the end cone pin into the corresponding positioning ring of the lower bracket, place the groove rubber ring under the upper guide frame, and then press it tightly with the diagonal pin.

After covering, first test whether its rotation is flexible. Rubber seal is used for the combination of the top cover and the cleaning outdoor ring to protect the closing seal under the top cover.

4. Ash hopper, filter chamber cylinder, clean room entrance door. Sealing packing should be embedded. Explosion proof (based on actual reports) (based on actual reports) (based on actual reports) Tighten bolts to prevent air leakage, such as doors, observation holes, and other flanges.

After installation, each transmission component should be filled with lubricating oil, and then try to check if the reducer wiring is reversed. If reversed, it should be reconnected immediately to avoid damaging the components. Only with correct confirmation can it be officially launched.

During operation, each transmission component should be regularly oiled, the blowback arm should be checked for normal operation, and the blowback automatic control system should be regularly inspected to prevent malfunctions. Regularly stop checking the filter bag. If the filter bag is found to be damaged, it should be replaced promptly.

7. Domestic pulse bag filter; Generally, it is sprayed regularly, every 30-60 seconds for 0.1-0.3 seconds each time. The fatigue strength and reputation index of the film are generally 150000 times. When the dust collector operates continuously, the service life of the membrane is 2/3 months. Correctly select the filtration speed and confirm the purification efficiency of the dust collector.

In the future, the area of dust removal bags in each zone will determine the most favorable length, diameter, and display spacing of dust removal bags. The ordinary length spacing of dust removal filter bags should not be less than 50mm; for particularly long (such as exceeding 3m) dust removal filter bags, the spacing should be larger.

9. Dust filter bags should be grouped and a channel should be left between the two groups. If there is only a channel on one side, the diameter of the dust removal bag should be 150mm, and each set of filter bags should not exceed three or four rows; Each set of filter bags with a diameter of 300mm shall not exceed two rows. If there are channels on both sides, the diameter of 150mm shall not exceed eight rows, and the diameter of 300mm shall not exceed four rows. The channel width is 450-600 millimeters. The total number of dust filter bags in each group depends on the vibration thinking structure used. In the mortal world, a set of filter bags is controlled by a set of vibration head structures. A compartment can include several sets of filter bags.